Usage of Plastic Grinding Machine Equipment
Nowadays, many customers who purchase plastic grinders are not very familiar with their operation and startup process, which has led to many equipment questions. From the user's perspective, Yingchuang Rolling Plastic Equipment will once again introduce the startup process, protection and maintenance methods of plastic grinders.
Usage of Plastic Grinding Machine Equipment
The use of plastic grinding machines must follow the process, otherwise problems may occur.
Firstly, the plastic grinding machine should be sturdy with the power unit device. If the machine equipment needs long-term operation, cement should be used to firmly fix the machine. If the equipment is active for tasks, the unit should be installed on an angle iron seat made of steel, and the power machine and plastic powder mill belt grooves should adhere to the same rotation three-dimensional.
Secondly, after the installation of this equipment is completed, it is necessary to check if the machine is loose. If it does not meet the requirements, it should be adjusted in a timely manner. Next, before starting the machine, rotate the rotor by hand to check if the teeth, hammer, and rotor are sensitive and reliable during operation, whether the rotation direction of the rotor is consistent with the direction indicated by the machine arrow, and whether the smoothness between the power machine and the plastic crusher is good.
Then, after starting the operation, the machine will idle for a few seconds before feeding if there are no abnormalities. After starting the operation of the plastic grinder, it is necessary to pay attention to the working condition of the grinder at all times and adhere to uniform feeding. Finally, after the machine and equipment have been operating for a period of time, it is necessary to regularly check the equipment to prevent problems and eliminate the possibility of problems appearing during the operation. In terms of equipment maintenance, the primary protection part of the plastic grinder is the protection of the equipment bearing. After the equipment works for a certain period, it is necessary to use Molybdenum disulfide or grease to smooth the equipment bearing to cool down the bearing. Secondly, it is necessary to regularly check the fixing bolts of each part of the equipment and use a pressure wrench to tighten them.